Archive

Please reload

July 31, 2018

I'm making a War Hammer.  If you don't know what a War Hammer is, don't worry, I didn't either.  This is a tool that was designed by Matt Moore to help cross fit athletes change weights when they're using barbells without a bench.

Here's how I understand it, though...

July 7, 2018

The Whiskey Crate is complete!  The video below shows the progress and outlines the work that I did to put it together.

Thanks for watching!

June 30, 2018

The whiskey crate is really coming along.  Check out the video to see the progress.

 Thanks for watching!

June 15, 2018

I'm continuing work on the whiskey crate.  If you haven't checked out the other couple of entries on this project, please look at parts 1 and 2.  

This week, I finished up most of the carving, though I still need to carve the recipient's name on the lid of the crat...

June 7, 2018

I've been working some more on the whiskey crate and the sides are nearly done.  

This is really a great and fun build.  The crate incorporates a TON of different techniques.  I've done some hand-cut dovetails, some routing -- both with a circle cutting jig, a ton of ca...

June 3, 2018

I'm honored to be working on a Whiskey Presentation Crate.  This is going to a gentleman who is retiring from the Air Force after serving for 26 years, so I'd better make it good!

The overall design is a walnut crate with maple accents.  The dimensions are about 19 inch...

May 25, 2018

Well, I completed the chainsaw desk organizer.  It was pretty much just some grunt work since the last update.  I glued, drilled, chiseled, finished, waxed and shot this awesome video.

Thanks for checking it out!

May 24, 2018

It's been a little while since the last post.  I've been busy working on some projects for friends.  I'm currently working on another, and this one isn't just for a friend, but it's also for a great cause!

I have a close friend who works for the Virginia Department...

March 30, 2018

The Baptismal Font is complete just in time for Easter!  I knew it would happen, and I'm very happy with the results...even if I had to make two of them to get it right.

While making version 1.0 of the font, I had a slip up and ended up having to re-cut a series of join...

February 14, 2018

I'm making progress on the baptismal font.  This video is a bit less technical and shows the process that I use on most of my projects.  I begin with rough cut lumber from my local hardwood dealer and mill it into a usable size.  Sometimes I just need two flat and para...

Please reload

  • Facebook
  • YouTube
  • Instagram

Reva, VA 22735, USA

©2017 by Flying WoodShop. Proudly created with Wix.com